If the line fuse blows the washer won t start.
Maytag bravos xl mct washer won t start.
I have a maytag bravos washer mtw6600tq0 that won t start.
The washer has attempted to fill and begin a wash cycle.
I set it up on blocks so i can see under it and looks to be coming from the basket underneath when th.
If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch.
Other problems include stopping at mid cycle loud noise and failure to drain and spin.
If the timer is defective the motor will not turn therefore no washer agitation.
Water level switch the water level switch aka pressure switch controls the water level.
Depending on your model some washers may fill without the lid locking and others will not even start until the lid locks.
Check your owner s manual for information on your specific model.
The lid must be completely closed and latched for the washer to operate.
I have a mct bravo xl and it won t start a new load it is stuck on deep water and won t start.
To determine if the thermal fuse is at fault use a multimeter to test it for continuity.
The washer turns on when the power button is pressed answered by a verified appliance technician we use cookies to give you the best possible experience on our website.
Click here for more information on the lid locking.
Common problems with maytag bravos washers include failure to start water filling slowly water leakage failure of the door or lid to lock and overflowing.
Close lid and press start.
It does not look to be coming from a hose.
Timer the timer supplies power to turn the motor.
If the washer is overloaded it will drain any water and detergent that was added during the fill.
A bad lid switch will make it so power cannot get to the drive motor.
In addition you should investigate and resolve the problem that caused the fuse to blow.
I have a maytag bravos xl washer that is leaking water.
To correct the overload remove several items and add detergent.
