The door lock can fail either mechanically or electrically.
Maytag centennial washer door locked.
If the door lock is damaged or does not latch properly replace it.
You ll need to remove the top panel to release the door lock and replace the latch assembly if it won t unlock.
If the door lock is defective the washer door will not latch properly.
Pausing the wash cycle is how it can be disabled.
Their has been a issue with newer washers including this one here s a simple easy way to bypass the lid lock good luck and please don t stick your hand in th.
At the start of a cycle the washer attempts to lock the door 6 times.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Without a model number i can t give you a specific answer but if you have a maytag mah style front load washer the door can be unlocked by pulling the release cord located in the dispenser area.
Ok so it sounds like your door lock may have failed.
If that doesn t work leave the washer plugged in for 20 minutes and it should unlock.
Door not completely closed due to interference.
Check door lock mechanism for damage misalignment or foreign objects.
Inspect the door lock for damage.
You will have to remove the dispenser bezel trim to access the cord to pull it to open the locked door.
The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress.
The lid will lock and the machine will enter a pump out mode for 8 minutes.
A lock icon appears on the front of the washer s control panel to indicate the lid is locked and also displays the current progress of the cleaning cycle depending on the model of your maytag washer.
This is a guide about unlocking the door on a maytag front load washer.
The door lock secures the washer door shut during operation.
First try to just unplug the washer for 60 seconds to see if the electronics will reset.
See the first image below.
If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor.
Once the washer door is closed the washer can begin operating.
