Located on the bottom of the door switch lock mechanism is a tear shaped tab.
Maytag maxima steam washer door locked.
Without a model number i can t give you a specific answer but if you have a maytag mah style front load washer the door can be unlocked by pulling the release cord located in the dispenser area.
You will have to remove the dispenser bezel trim to access the cord to pull it to open the locked door.
During this period you will be able to hear the pump running.
Clear any debris out of the door lock assembly.
The door can be manually unlocked.
You may also want to test all wiring connections leading to the lock.
Unplug the washer and check the door lock assembly for damage or a loose wiring connection.
My maytag maxima steam washer door is locked and will not open.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
See the first image below.
Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
Gently pull the tab down about 1 4 inch or until a click is heard.
We use cookies to give you the best possible experience on our website.
The door can t lock.
The door should unlock after 60 seconds.
Fresh hold option is on.
The washer door will unlock at the end of the drain.
Replace the door lock switch if defective.
Disconnect the power cord from the power source.
The code goes on in case your washer cannot lock the door.
Disconnect the washing machine from the mains grid and inspect the door lock unit for any possible damage.
Remove the lower access panel.
This is a page about unlocking the door on a maytag front load washer.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
The door lock led light will blink.
The door may immediately unlock.
Run a drain and spin cycle.
The control lock light is on as well.
It would be a good idea to see if no debris has stuck in the door lock unit.
Select drain spin to remove any water remaining in the washer.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Reach up along the inside of the front and locate the bottom of the door switch lock mechanism.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
After 8 minutes the door will unlock.
Wait approximately 2 minutes for control to reset.
Nothing else will appear to be happening with the machine during this time.